I have heard there are oil questions on the G2 exam? have others noticed this? if so are they related to conversions? Also I would like to know what modules to focus on for studying.
thanks for any info...
I've never seen the Gas Technician modules, but the code book only mentions oil in Clause 4.3.5(a)(b);
Quote(4.3.5) When the installation or conversion of an appliance constitutes a conversion from another form of energy, the installer shall advise the user of the appliance, at the time of installation or conversion, to have the former form of energy either removed or left safe and secure from accidental activation; for example, the user shall be advised
(a) in the case of a fuel oil supply tank
(i) to remove the fill pipe, and cap or plug the exposed fill pipe opening to an inside tank; however, do not remove the vent pipe;
(ii) shut off the tank outlet valve, remove the filter, and plug or cap the valve outlet;
(iii) where the tank is located outdoors, disconnect all exposed piping as close as practicable to the tank; cap or plug the exposed fill pipe opening to the tank; however, do not remove the tank vent pipe; and
(iv) advise the owner/operator of the tank in writing that the tank may be required to be removed in accordance with the Fuel Oil Regulation and the oil shall be removed by a certificate holder trained for that purpose.
Oil questions should only be on the Oil Burner Technician certification exam.