please help !! No heat

Started by aniki1516, January 01, 2009, 08:37:15 AM

Previous topic - Next topic

aniki1516

gas furnace.
The furnace suddenly stop working. filter really dirty no heat coming out so i turned off and replaced filter,    I removed the panel to reveal the circuitry.  When I depress the  safety lockout switch I hear a humming fron the transformer, after a few seconds when I release the switch I hear a clicking sound like a solonoid. its not the blower fan because when i put the thermostat lower the blower fan starts  What part could it be and how would I check it out.   I can tak a digital picture of the guts and send it via email if that would help. help help   Its New Years and it is cold.   thanks a \lot
anu help would be gratly appreciated!!

Admin

I think the safety switch you're referring to is the door switch.  It interupts power to the furnace when the door is off.  You're just hearing the relay energize and de-energize.
I don't understand how lowering the thermostat would cause the fan to start... What kind of furnace do you have?

aniki1516

i have aire ire flo gas furnace, its the inducer blower thats making noises it seems like its trying to start?...the motor is very hot, could the motor be psibly blown, is this expensive to fix, thanks alot for your reply

Admin

That's a low end furnace, probably a $500 service call.
Call a Lennox dealer for that part.

Your diagnosis sounds correct.  Verify the drainage is clear if it's a high efficiency furnace,  a plugged drain could have caused the venter to overheat.

aniki1516

thanks alot , i wanted to install it myself ive taken off the old inducer blower, the only problem is that i dont have a license to buy the part from lennox. ......I found another place that carrys it that will sell to me, but for 475 dollars does that sound fair? please any suggestions would be greatly appreciated, Thanks

Admin

Get Lennox to give you the part number, you might be able to cross reference a Rotom motor for less.
$475 is the retail price no doubt.  Make sure you re use the restrictor disc from the back of the old motor if there is one. 

The ALLTEMP ROTOM webpage is - Here

Look under Products, Heating Parts, Flue Exha. Mtrs & Blowers or click - Here